|
PIN MARK TOOL |
|
|
|
|
|
The setting of Pin-Mark is safer and far easier to drive into hard concrete surfaces, the head of the Pin-Mark is inserted into the end of the setting tool where it is securely held in position.
A twist breaks the top of the pin off.
The insertion tool is especially hardened, has a safety sleeve and is designed to be used with a club hammer.
Protects the hands and makes the setting of the mark far more accurate.
| Product |
|
Code |
| Pin Mark setting tool |
B25138 |
|
|
|
|
 |
|
|
|
|
The Pin-Mark is 18mm under head which is long enough for most applications and can be driven into steel, timber and even the hardest concrete.
The protruding pin head stands off the surface approximately 9mm and when used in walls, will act as a levelling point. Should you not require the protruding head then it can be snapped off after it has been hammered home leaving a 10mm wide marking head close to the surface.
| Product |
|
Code |
| 18mm Pin marks per 100 |
B25137 |
|
|
|
|
 |
|
|
|
|
A general purpose hammer for delivering close heavy blows.Precision ground striking faces, specially hardened and heat treated to withstand the most high impact heavy applications.Fitted with a selected fully seasoned hickory handle.Weight.2.1/2lb.
| Product |
|
Code |
| Club Hammer |
B25319 |
|
|
|
|
 |
|
|
|
|
NAILS |
|
|
|
|
 |
Steel masonry nails with a ribbed shaft to ensure a very strong and secure grip.
Zinc plated for corrosion resistance.
Use with road clamps with 0.250" nail holes.
6/16" Diameter - Length 1.25"
1/4" Diameter - Lengths 1.5", 2.0" & 2.5"
| Product |
|
Code |
| Length 1.25" CA199 |
|
|
|
| Length 1.5" CA200 |
|
|
|
| Length 2" CA201 |
|
|
|
| Length 2.5" CA202 |
|
|
|
|
|
 |
|
|
|
|
A smooth shafted masonry nail.
Austempered high carbon steel with an outer zinc plating for corrosion resistance.
Use with road clamps with 0.140" nail holes.
0.144" Diameter
| Product |
|
Code |
| Length 40mm CA203 |
|
|
|
| Length 50mm CA204 |
|
|
|
| Length 60mm CA205 |
|
|
|
| Length 800mm CA206 |
|
|
|
| Length 900mm CA207 |
|
|
|
| Length 100mm CA208 |
|
|
|
|
|
 |
|
|
|
|
White Zinc plated to protect against corrosion.
Hammered into the road surface (allowing you to spend less time in the road), giving your clamps a secure grip.
Unscrews, leaving the road surface intact and re-usable.
0.250" Diameter
Use with road clamps with 0.25" holes
| Product |
|
Code |
| Length 3" CA189 |
|
|
|
|
|
 |
|
|
|
